Re: Re: Re: Loose valves?


[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by Lew on December 05, 2001 at 14:35:07:

In Reply to: Re: Re: Loose valves? posted by James on December 05, 2001 at 14:04:24:

Any number of shops can have the valves plated for you. Almost all of them use Anderson plating to actually plate the valves, but the final result can vary depending on who does the final fitting to the casings. The Brass Bow (listed in the shops section of theis site) had a good description of the process on their web site. I think that Dan Oberloh also had a description on his web site, www.oberloh.com. Many of the shops listed here could do the work for you. Which you choose probably depends on proximity as much as anything else.


Follow Ups: