Re: Re: Re: Re: Help! I need repair advice!


[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by Klaus on September 20, 2001 at 02:36:16:

In Reply to: Re: Re: Re: Help! I need repair advice! posted by js on September 19, 2001 at 22:22:22:

Yamaha used cover their low brass valve springs with some epoxy like stuff. Good idea, bad execution, as it fastly begins to peel off.

B&H/Besson have soft, but shaped, valve dampers in form of circular "washers" to be placed within piston bottoms and bottom valve caps. They have grooves/recesses for the springs.

I had/have good experiences with them on my 981 Eb, so I bought 2 extra sets for my Conn 40K and my York Master. Dimensions are not exactly the same. But they actually work to their intended purpose.

Had I had some more dedication, I would have found some appropriate material and cut them myself. For a fraction of the cost.

Klaus


Follow Ups: