Re: Re: Asymetric Mouthpiece????


[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by Joe Baker on February 13, 2001 at 11:41:06:

In Reply to: Re: Asymetric Mouthpiece???? posted by Gus Pratt on February 12, 2001 at 16:33:44:

Okay, I'm going to step into one of those 'little knowledge/dangerous thing' realms here, so forgive me if I'm wrong, but wouldn't a programmable lathe be able to do this? If the tool feed were moved into and out of the work at the same speed as the work is turned, it seems like this could be done just fine. 'Course, I believe such a procedure is SLOW and the lathe is EXPEN$IVE!

Somebody with more extensive knowledge will, I hope, correct my misconceptions.



Follow Ups: